Bolondi SW053A Bin Cleaner - Hi Pressure Equipment Ltd.

Ph: 604.940.1599
Toll Free: 1.800.626.6465
Go to content
2175 PSI Wheelie Bin Cleaning Head
Water Powered Self Spinning

  • Larger more advanced turbine
  • Heavy-duty gear drive
  • Increased torque
  • Suitable for flow rates down to 3 US GPM

aisi 316 + bronze
10 to 60lt/min
3 to 16 us gpm
150 bar / 2175 psi
90°C. - 194°F.
Spinning speed:
Cleaning sector:
2 - 4 1/8 MEG
Washing speed:
100 RPM
Washing cycle time:
14 Sec.
3.5 KG - 7.8 Lbs.
SW053A Specifications
Bolondi High Pressure Filter

Protect Your Bolondi Cleaning Head

Filtering is your best defence against premature cleaning head wear, and preventing downtime.
As a hot water coil goes through its heating and cooling cycles.
The coil will release small metal particles called slag.
These particles must be filtered out prior to entering the cleaning head.
If these particles are not filtered out.
They will get lodged into a the cleaning heads diffuser.
The turbine will stop and the cleaning head will stop rotating.

The Bolondi filter is all stainless steel construction (except Teflon O-ring).
Resists corrosion from waterborne materials.
Heavy duty screen support prevents screen collapse for maximum performance.

Maximum operating pressure is 5000 PSI

Protect Both Your Hot Water Heater & Bolondi Cleaning Head

Scaltrol’s water scale solutions were designed to control mineral scale from water sources that cause corrosion and  decrease the efficiency of your appliances and plumbing.
Without a preventative scale control solution, your appliances eventually become clogged with scale buildup – sometimes past the point  of fixing.
Since most water sources are saturated with large amounts of  minerals, including calcium carbonate (lime scale), calcium sulfate, iron, and manganese, the Scaltrol units are installed at the water supply.
The concentration of minerals depends on your environment, based on  rock formation, pH level, oxygen content, and temperature.
Any increase or decrease in temperature can cause minerals to precipitate (i.e., form scale).

Preventing scale formation

To counteract mineral build-up, Scaltrol scale control units dispense a measured amount of polyphosphate which deposits a microscopic film to all surfaces. The mineral molecules, which have a positive charge, are then attracted to – and held in suspension by – the negative charge of the polyphosphate, which acts as a sequestrant. Since the mineral molecules are no longer able to bind together, scale cannot form.
Hi Pressure Equipment Ltd.
Unit #125-12051 Horseshoe Way,
Richmond, B.C.
V7A 4V4

Ph: 604.940.1599
Fax: 604.940.1595
Toll free: 1.800.626.6465
Back to content