Bolondi 250F - Hi Pressure Equipment Ltd.

Ph: 604.940.1599
Toll Free: 1.800.626.6465
Go to content
Bolondi SW060-316SS-250°F

3000 PSI @ 250°F Special High Temp
Waste Bin Cleaning Head
Water Powered Self Spinning

  • Heavy-duty cleaning head
  • High temperature 250°F
  • All aisi 316 stainless steel
  • Larger more advanced turbine

Material:
aisi 316
Flow:
15 to 60lt/min
4 to 16 us gpm

Pressure:
200 bar / 3000 psi
Temperature:120°C. - 250°F.
Spinning speed:
fast
Filter:
no
Cleaning sector:
240°
Nozzles:
2 to 4  1/8 MEG
Complete cycle:
150 Rotations
Complete cycle time:
15 Sec.
Weight:5.5 KG - 12.1 Lbs.
h
h
                 
Bolondi High Pressure Filter

Protect Your Bolondi Cleaning Head

Filtering is your best defence against premature cleaning head wear, and preventing downtime.
As a hot water coil goes through its heating and cooling cycles.
The coil will release small metal particles called slag.
These particles must be filtered out prior to entering the cleaning head.
 
If these particles are not filtered out.
They will get lodged into a the cleaning heads diffuser.
The turbine will stop and the cleaning head will stop rotating.

The Bolondi filter is all stainless steel construction (except Teflon O-ring).
Resists corrosion from waterborne materials.
Heavy duty screen support prevents screen collapse for maximum performance.

Maximum operating pressure is 5000 PSI
h
                 
Scaltrol

Protect Both Your Hot Water Heater & Bolondi Cleaning Head

Scaltrol’s water scale solutions were designed to control mineral scale from water sources that cause corrosion and  decrease the efficiency of your appliances and plumbing.
Without a preventative scale control solution, your appliances eventually become clogged with scale buildup – sometimes past the point  of fixing.
Since most water sources are saturated with large amounts of  minerals, including calcium carbonate (lime scale), calcium sulfate, iron, and manganese, the Scaltrol units are installed at the water supply.
The concentration of minerals depends on your environment, based on  rock formation, pH level, oxygen content, and temperature.
Any increase or decrease in temperature can cause minerals to precipitate (i.e., form scale).

Preventing scale formation

To counteract mineral build-up, Scaltrol scale control units dispense a measured amount of polyphosphate which deposits a microscopic film to all surfaces. The mineral molecules, which have a positive charge, are then attracted to – and held in suspension by – the negative charge of the polyphosphate, which acts as a sequestrant. Since the mineral molecules are no longer able to bind together, scale cannot form.
Hi Pressure Equipment Ltd.
Unit #125-12051 Horseshoe Way,
Richmond, B.C.
V7A 4V4

Ph: 604.940.1599
Fax: 604.940.1595
Toll free: 1.800.626.6465
Back to content